Temperature probe with display
Fitted with 4 keys to select the temperature required and the mode of operation. It can also be used in mixed heating/cooling systems and as a 1 zone control unit.
Heat only when and where you need it.
FEATURES
Online catalogue
Range
System composition
The MyHOME_Up temperature control system consists of the following devices:
- Probes with and without display
- Actuators
- Power supply
We can create 2 types of systems with the possibility of managing up to 99 zones:
- By installing the display probes used as a zone thermostat, and with probes without display and related actuators. With the MyHOME_Up application, the system is started up and the relative operation of the individual devices is checked. It is also possible to define heating activation programs with customized profiles.
- By installing the MyHomeServer1 gateway, in addition to the various probes and actuators, the system can also be managed by the HOMETOUCH touch screen and by Smartphone with the MyHOME_Up App. It is also possible to define heating activation programs with customized profiles. Also integrating the Driver manager device art. F459 it will be possible to manage third-party heating and cooling systems with the aforementioned devices.
Temperature probes with or without local adjustment
Made to measure the temperature between 3 – 40°C, these devices are available with and without adjustment knob and in the specific version to manage the fancoil speed.
Probe without display
3454 temperature probe in basic module with wired sensor - to be associated to the temperature sensor item 3457. Range 0 - 40 °C
Actuator with 2 relais
2 independent relay actuator – for single and double loads: 6 A resistive, 2 A motor valves and pumps - logic relay interlock via configuration - 2 DIN modules
Actuator with 4 relais
4 independent relay actuator - for single, double and combined loads: 4 A resistive, 1 A motor valves, pumps and fan-coil - logic relay interlock via configuration - 2 DIN modules
Actuator with 8 relais
Actuator with 8 independent relays for the control of on-off valves, motorised valves (open-close and three points), pumps and fan coils with 2 and 4 tubes – 4A resistive, 1A motor valves, pumps and fan-coils - SCS bus connection, 4 DIN modules.
Actuator with 3 relais
Actuator with 3 independent relays and 2 x 0-10 Volts outputs for the control of fan coils with 2 and 4 tubes with proportional 0-10 Volt valves – 4A resistive, 1A fan coil - SCS bus connection, 4 DIN module.
Actuator with 2 output 0-10V
Actuator with 2 x 0-10 Volt outputs for the control of 0-10 proportional valves - SCS bus connection, 2 DIN modules
HOMETOUCH device for displaying and controlling loads.
The new HOMETOUCH can be integrated into the system, capable of displaying the status of the loads controlled by the control unit and forcing operation independently of the control unit itself.
The system configuration
The commissioning of the system and the definition of the functions with the actuator control association, is easily carried out by using the MyHOME_Up app and the MyHOME Server1 gateway connected to the BUS and the Internet.
Galleries
INSTALLATION
Installation suitability
Temperature regulation system devices are installed in the same way as traditional devices. Depending on the item the installation can be made:
- In flush-mounted boxes;
- In DIN switchboards;
- Wall mounted.
To connect the devices the BUS wiring must be made via unpolarised two-wire cable. All the devices must be configured to assign the address and the operating mode.
The operating modes of the devices are defined using the MyHOME_Up application for Smartphones and Tablets.
