3-input electricity meter
Device to measure a maximum of 3 electrical lines via toroids. The consumption data are supplied instantaneously or cumulatively on an hourly, daily and monthly basis.
MyHOME_Up: display of energy, water and gas consumptions
Complete check up of the consumptions and energy produced.
FEATURES
Range
System composition
The system includes the following devices:
- Pulse counter interfaces for water and gas measurement;
- Electricity meters with toroids
- MyHome_Screen 3.5, MyHome_Screen 10 and Display energy display devices.
All the devices are connected using the 2-wire BUS wiring.
Bus technology: All the devices connect each other using a 2 conductor cable, used for carrying information and the 27 Vdc power supply.
Aesthetic Integration: The original feature of the MyHOME_Up system, from the simple digital control to the most advanced Touch device, is the perfect integration in the Axolute, Livinglight and Màtix ranges.
Pulse counter interface
The device detects, counts and processes the information from the water, gas, etc... counters with impulse output. The consumption data are supplied on an hourly, daily and monthly basis.
Energy display
Device with 1.6" display, for the display of the energy consumption data, and for the control of the actuators of the Energy Management system.
Touch screen display devices
MyHome_Screen 3.5 and MyHome_Screen 10 are devices commonly used to control MyHome functions and can be used to display energy consumptions on an hourly, daily and monthly basis, by means of graphs and tables.
Local and remote consumption display via MyHOME_Up App
This application, with the help of the MyHOMEServer1 gateway in the system, allows to view instant consumption data and use it to generate scenarios. For example, it is possible to activate the cooling system when the photovoltaic system produces a specific amount of electricity.
Device configuration
The addresses and the functions performed by the devices are configured manually by means of numerical configurators or PC using specific programs, such as MyHome_Suite and others.
Galleries
INSTALLATION
Installation suitability
The Temperature regulation system devices are installed in the same way as traditional devices. Depending on the item they can be installed in flush-mounting and wall-mounting boxes and in DIN switchboards. To connect the devices they must be BUS wired via non-polarised two-wire cable. All the devices must be configured to assign the address and the mode of operation.
